Question 1

What makes fit-out RAMS different from other construction RAMS?

Accepted Answer

Fit-out RAMS focus on internal finishing works rather than structural activities. Key differences include the emphasis on dust control (MDF and plasterboard dust are significant health hazards), coordination with other trades in confined interior spaces, and the use of low-level access equipment like podium steps and hop-ups rather than full scaffolding. Fit-out RAMS also cover fire compartmentation and service penetration sealing.

Question 2

Is MDF dust a COSHH substance?

Accepted Answer

Yes. MDF (Medium Density Fibreboard) dust is classified as a hazardous substance under the COSHH Regulations 2002. The Workplace Exposure Limit (WEL) for hardwood dust, which includes MDF, is 3 mg/m³ (8-hour TWA). Your RAMS must include dust extraction at source, RPE (FFP2 minimum, FFP3 recommended), and controlled cutting areas. The generator flags MDF work automatically.

Question 3

How does the generator handle multi-trade coordination?

Accepted Answer

The generator includes a coordination section where you can identify other trades working in the same area, specify permit-to-work arrangements (e.g., hot works for fire stopping), and define access restrictions. It generates a method statement that accounts for shared work areas, sequential activities, and the need for regular coordination meetings between trade supervisors.

Question 4

Can I include fire stopping and compartmentation in my fit-out RAMS?

Accepted Answer

Yes. The generator covers fire stopping around service penetrations, fire barrier installation above ceilings, and compartmentation integrity maintenance. It includes the requirement for third-party fire stopping certification and references the Building Regulations Approved Document B. Fire stopping work may require a hot works permit if using intumescent sealants with heat application.

Question 5

What dust control measures should a fit-out RAMS include?

Accepted Answer

Effective dust control for fit-out work includes on-tool extraction (H or M class vacuum), designated cutting areas with local exhaust ventilation, wet cutting for tiles and concrete, regular housekeeping, RPE (FFP2/FFP3 depending on the material), and health surveillance for operatives regularly exposed to wood or silica dust. The generator includes all relevant measures based on your selected activities.

Fit-Out RAMS Template — Generate in Minutes

What's Included in Your Fit-Out RAMS

Fit-Out RAMS — Frequently Asked Questions

Related Trade RAMS